The APICULTURAL SOCIETY OF KOREA
[ Original Article ]
Journal of Apiculture - Vol. 32, No. 4, pp.359-362
ISSN: 1225-0252 (Print)
Print publication date 30 Nov 2017
Received 01 Oct 2017 Revised 22 Nov 2017 Accepted 22 Nov 2017
DOI: https://doi.org/10.17519/apiculture.2017.11.32.4.359

Biometric Studies of the Stingless Bee Tetragonula laeviceps Complex (Apidae: Meliponini) from Northern Thailand

Bajaree Chuttong1, * ; Michael Burgett2
1Science and Technology Research Institute, Chiang Mai University, Chiang Mai, Thailand 50200
2Department of Horticulture, Oregon State University, Corvallis, OR (USA) 97331

Correspondence to: * E-mail: bajaree@yahoo.com

Abstract

Biometrical information for five colonies of the Tetragonula laeviceps complex from Chiang Mai province, Thailand, was collected. The examination was conducted from September to November 2016. The range of colony age was one to five years. Results reveal an average number of queens (2.0±0.7), workers (5,823.6±2,703.3), drones (349.8±701.0), brood cells (9,911.0±4,795.3), honey pots (433.0±312.4) and pollen pots (711.8±305.9). The average size of a honey pot was 6.1±1.0mm in width and 7.3±1.1mm in height. The average size of a pollen pot was 6.4±0.3mm in width and 7.7±0.4mm in height. The results show intraspecific variation within the species that is the most common stingless bee species used in Thai meliponiculture. These observations support the contention that T. laeviceps complex comprises a cryptic species.

Keywords:

Tetragonula laeviceps, Stingless bees, Colony biometrics, Cryptic species

INTRODUCTION

Considering the number of described stingless bee species in the Indo-Malayan/Australasian region to be 89 (Rasmussen 2008), the colony bionomics of only a relatively few species have been investigated. The number of meliponine species in Thailand is stated to be 32 (Rasmussen 2008). An early report of nest architecture and colony composition of Tetragonula laeviceps is that of Sakagami et al. (1983) who examined colonies in Sumatra (Indonesia). A more recent report is that of Chinh et al. (2004) from a study of T. laeviceps in Vietnam.

Tetragonula laeviceps is one of the most widely distributed and most commonly used stingless bee species in Thai meliponiculture (Chuttong et al., 2014). Tetragonula laeviceps is opportunistic in nest site selection often utilizing anthropogenic cavity structures which is a primary factor for its incorporation into stingless bee beekeeping. The taxonomic placement of T. laeviceps is in question and is considered to be a cryptic species complex (Michener 2007, Khamyotchai et al., 2015). The first taxonomic description of T. laeviceps is from Singapore (Smith, 1859). Due to the geographical breadth of the species and varying architectural features of nests, it can be assumed, as stated by Rasmussen (2008), species limits are uncertain.

The purpose of the work we report is to elucidate T. laeviceps complex colony bionomics as observed in northern Thailand with managed colonies.


MATERIALS AND METHODS

We obtained five colonies of T. laeviceps complex from local meliponiculturists in the northern Thai province of Chiang Mai. The colonies varied in age from 1 to 5 years. While there was no standard unit size, our colonies were housed in ‘hives’ of ca. nine liters in volume. Colonies were euthanized by freezing prior to the careful dissection of colony matrices. We measured the following parameters: number of adult workers, males, and queens were counted under microscope, number of brood cells, pollen and honey pots were counted individually, and their respective volumes were measured by the digital caliper. Colony examinations took place during the late wet season of 2016 (September-November) at the Meliponini and Apini Research Laboratory, Postharvest Technology Research Center on the Chiang Mai University campus, Chiang Mai, Thailand.


RESULTS AND DISCUSSION

From the summaries (Tables 1 and 2) there are considerable differences shown in the total number of workers per colony, with the most populous colony (#3) being the oldest examined colony (5 years of age) with 3 times more workers than the smallest population seen in colony #1 (2.5 years of age). Our average of 5,824 workers is 5 times larger than the biggest colony worker population reported by Sakagami et al. (1983) in Sumatra, but is comparable to an average worker population of 4,221 for colonies examined in Vietnam (Chinh et al., 2004).

Individual colony metrics

Average size and volume of honey pots, pollen pots and brood cells

The number of adult male bees was the statistic with the greatest variability, with a range of 3 males in a population of 3,400 adults (colony #1) to 1,603 males in a population of 11,909 adult bees, where the males comprised 13.5% of the adult population (colony #3). When compared with the work of Sakagami et al. (1983) who found male populations to range from 0 to 10% of the adult population, our results are very similar.

Four of the five examined colonies possessed more than one queen with colony #3 possessing 3 queens. Examination of the 4 multiple queen colonies revealed that in each instance only one queen was in a reproductive state exhibiting physiogastry, while the other queens (nonphysiogastric) are assumed to be daughter virgin queens.

The average number of brood cells was 9,911 with an inter-colony range of 5,135 to 16,633. The brood cell to worker bee ratio ranged from 1.99 to 1.24 with an average of 1.69. The brood combs were in stacked layers, in what could be described as a spiral-like configuration with the layers being vertically separated by short pillars. Sakagami et al. (1983) characterizes the brood cells examined in Sumatra as amorphous clusters as does Chinh et al. (2004) for those examined in Vietnam. Such is not the case with the colonies we examined as shown in Fig. 1. Our results, for the size of individual brood cells (2.44mm in width by 3.31mm in height), is in contrast to the report of Chinh et al. (2004) which describes brood cells with a width of 2.4 and being ca. 4.5-5mm in height which makes them considerably greater in volume than those we observed in northern Thailand.

Fig. 1.

Brood cells of Tetragonula laeviceps complex; top view (A), side view (B).

Our measures for honey pot height results in an average of 7.3mm, which differs rather sharply with the height given by Chinh et al. (2004) of 12-15mm.

Food reserves were calculated from the average volumes of honey and pollen pots multiplied by the average number of honey and pollen pots per colony. For our five colonies that calculation results in an average honey store of 62ml of honey and a pollen volume of 118ml. The colony with the most honey pots (768 pots) would hypothetically contain ~107ml of stored honey. The largest of 3 colonies examined by Sakagami et al. (1983) possessed 21ml of honey.

The results of our examination show some interesting differences from previous published research of T. laeviceps colony biometrics (Sakagami et al., 1983 and Chinh et al., 2004) most especially as concerns the size of honey pots (see Table 3). Additionally, the structure of the brood nests for all our examined colonies, as mentioned, was in a layered, spiral-like form, which is in contrast to an amorphous aggregation of brood pots reported by both Sakagami et al. (1983) and Chinh et al. (2004). The reported brood cell dimensions from these two previous reports also are in contrast to our findings (see Table 3).

Size of honey pots and brood cells in comparison to other T. laeviceps studies

Our observation of 4 of 5 colonies possessing multiple queens aligns with previous studies for T. laeviceps as well as other stingless bee species. In stingless bees, queens can be produced all year round. The number of queens depends on the species and condition of the colony. Productive colonies with sufficient food storage may possess multiple queens (Bradbear, 2009; Engles and Imperatriz-Fonseca, 1990). The report of Chinh et al. (2004) found the number of queen cells in T. laeviceps colonies ranged from zero to seven and for Lisotrigona carpenteri from none to fourteen.

Adult worker specimens from our five examined colonies were taxonomically assigned to the T. laeviceps complex by Dr. H. Banziger who is arguably the preeminent meliponine taxonomist in SE Asia. His identification is based on Rasmussen and Michener (2010).

Our observations concerning brood nest architecture and brood pot and honey pot dimensions in northern Thailand differ when compared to earlier work examining T. laeviceps from more southern latitudes. This fortifies the hypothesis that this group is a cryptic species complex. Future work utilizing molecular genetics will go far in unraveling the taxonomic conundrum that T. laeviceps represents.

Acknowledgments

We sincerely thank Dr. H. Bänziger of Chiang Mai University for the bee identifications. We also thank the following students from Maejo University for their yeoman’s service in colony dissections; Ms. Benjawan Chaiyatip, Ms. Janjira Yavilat and Mr. Panuphan Sangjaroen. We thank Assist. Prof. Yaowaluk Chanbang of the Postharvest Technology Research Center, Chiang Mai University for generously providing the laboratory facilities.

LITERATURE CITED

  • Bradbear, N., (2009), Bees and their role in forest livelihoods: a guide to the services provided by bees and the sustainable harvesting, processing and marketing of their products.?, Non-wood Forest Products, (19).
  • Chinh, T. X., Sommeijer, M. J., Boot, W. J., & Michener, C. D., (2004), Nest architecture and colony characteristics of three stingless bees in North Vietnam with the first description of the nest of Lisotrigona carpenteri Engel (Hymenoptera: Apidae, Meliponini), Chinh, TX, Sommeijer, MJ, Boot, WJ y, Michener, CD, Reproduction in Eusocial Bees, p26-39.
  • Chuttong, B., Chanbang, Y., & Burgett, M., (2014), Meliponiculture: Stingless Bee Beekeeping In Thailand, Bee World, 91(2), p41-45.
  • Engels, W., & Imperatriz-Fonseca, V. L., (1990), Caste development, reproductive strategies, and control of fertility in honey bees and stingless bees, In Social Insects, p167-230, Springer Berlin Heidelberg, [https://doi.org/10.1007/978-3-642-74490-7_9] .
  • Khamyotchai, K, Bänziger, H, Kulsarin, J., (2015), Nest entrance types of Tetragonula laeviceps (Smith) a stingless bee species complex (Hymenoptera: Apidae: Meliponini) in Thailand and peninsular Malaysia (In Thai), Journal of Agriculture, Faculty of Agriculture Chiang Mai University, 31(1), p1-9.
  • Michener, C. D., (2007), The Bees of the World, 2nd. Ed., Johns Hopkins, Baltimore.
  • Rasmussen, C., (2008), Catalog of the Indo-Malayan/Australasian stingless bees (Hymenoptera: Apidae: Meliponini), Auckland, Magnolia Press.
  • Rasmussen, C., & Michener, C. D., (2010), The identity and neotype of Trigona laeviceps Smith (Hymenoptera: Apidae), Journal of the Kansas Entomological Society, 83(2), p129-133, [https://doi.org/10.2317/jkes0907.08.1] .
  • Sakagami, S., Inoue, T., Yamane, S., & Salmah, S., (1983), Nest architecture and colony composition of the Sumatran stingless bee Trigona (Tetragonula) laeviceps, Kontyu, Tokyo, 51(1), p100-111.
  • Smith, F., (1859), Catalogue of hymenopterous insects collected by Mr, AR Wallace at the Islands of Aru and Key. Zoological Journal of the Linnean Society, 3(11), p132-158.

Fig. 1.

Fig. 1.
Brood cells of Tetragonula laeviceps complex; top view (A), side view (B).

Table 1.

Individual colony metrics

Colony No. Number of
Workers Males Queens Brood cells Honey pots Pollen pots
1 3,395 3 2 5,530 420 716
2 4,153 36 2 5,135 85 1,212
3 10,303 1,603 3 16,633 768 645
4 6,084 75 2 12,085 749 602
5 5,183 32 1 10,172 193 384
Average 5,823±2,703 349±701 2±0.71 9,911±4,795 443±312 712±306

Table 2.

Average size and volume of honey pots, pollen pots and brood cells

Measures Width (mm) Height (mm) Volume (mm3)
Honey pots 6.06±0.96 7.30±1.05 140.29
Pollen pots 6.41±0.25 7.74±0.39 166.40
Brood cells 2.44±0.15 3.31±0.14 10.32

Table 3.

Size of honey pots and brood cells in comparison to other T. laeviceps studies

Size of honey pots (mm) Size of brood cells References
Mean±SD Range Range
Width (mm) 6.1±0.1 5.0-7.1 2.3-2.6 This study
7.8±1.6 5.0-11.0 ~ 3.0 Sakagami et al., 1983
NR 5.0-7.0 NR Chinh et al., 2004
Height (mm) 7.3±1.1 6.2-8.3 3.1-3.5 This study
9.4±1.6 7.0-14.0 ~ 3.9 Sakagami et al., 1983
NR 12.0-15.0 4.5-5 Chinh et al., 2004